Aerospace Knowledge and Technology Journal

Aerospace Knowledge and Technology Journal

Aerospace Knowledge and Technology Journal

Journal Archive

Most Visited Articles
The effect of loss parameters using tandem blade in axial compressor
Investigation of Fin Span Effect on Performance of Missile on its Aerodynamics Analysis
Fracture parameter determination for a thin walled pressurized cylinder under the influence of residual stress induced by welding process
Experimental study and Optimization of Manufacturing Parameters of High Silica-Phenolic/Glass-Epoxy Laminate insulators in order to achieve the Highest thermal resistance and inter-laminar Strength
Integrated guidance and control of the surface-to-air homing missile Pitch channel using optimal neural network
Design of a Navigation System for an Unmanned Air Vehicle Equipped with a Bearing-Only Sensor
Computational Investigation of Mach number and angle of Attack Effects on the Flow Pattern over a 60º Delta Wing
Current Issue: Volume 15, Issue 1, September 2026 

Dynamic analysis of a rotor-disk system with unbalance and internal damping on a viscoelastic foundation

Mahmood Raeiszadeh Kooshkghazi, Majid Bakhtiari, Kamran Daneshjou, Ali Tarkashvand

Keywords Cloud

  • Optimization
  • numerical simulation
  • satellite
  • UAV
  • flow control
  • Uncertainty
  • Modeling
  • genetic algorithm
  • Multi-objective optimization
  • optimal control
  • Sensitivity analysis
  • Attitude control
  • Heat Transfer
  • Simulation
  • Piezoelectric
  • Missile
  • finite element method
  • Numerical method
  • quadrotor
  • Nanocomposite
  • integrated guidance and control
  • Inertial navigation
  • Computational fluid dynamics
  • modal analysis
  • fault detection
  • supercritical airfoil
  • launch vehicle
  • thrust
  • Aerodynamic coefficients
  • three-body problem
  • oscillating airfoil
  • FEM
  • Carbon Nanotube
  • Control
  • Neural network
  • Cavitation
  • supersonic flow
  • Thermal management
  • delta wing
  • Performance
  • energy absorption
  • Trajectory Tracking
  • Combustion chamber
  • Finite element
  • Calibration
  • liquid fuel
  • flight simulator
  • semi elliptical crack
  • Fault tolerant control
  • design optimization
  • Transverse Injection
  • Rudder
  • Bending test
  • Corona Plasma Actuator
  • Groove
  • Free vibration
  • temperature gradient
  • Sound transmission loss
  • propulsion
  • nanofluid
  • flow visualization
  • Humidity
  • free convection
  • fault estimation
  • inverse dynamics
  • Cooling
  • Diesel
  • Porous materials
  • trajectory optimization
  • Reinforcement Learning
  • Plasma Actuator
  • cavity
  • Adaptive control
  • Axial compressor
  • Insulation
  • Magnetic field
  • Feedback linearization
  • central crack
  • unmanned aerial vehicle
  • PID Controller
  • Combustion Efficiency
  • statistical analysis
  • parity relation
  • Heat Pipe
  • stewart platform
  • Wind Tunnel
  • hazard rate behavior
  • Constrained optimization
  • Kerosene
  • PCM
  • CFD
  • UAV security
  • flying wing
  • Artificial neural network
  • Unsteady turbulent flow
  • Pareto Front
  • Active Vibration Control
  • Target Tracking
  • transient
  • Attitude Determination
  • Robust control
  • Spray Characteristics
  • Scramjet
  • liquid propellant engine
  • Path Planning
  • multidisciplinary design optimization
  • voltage
  • Film cooling
  • Conceptual design
  • reaction wheel
  • interior ballistics
  • Lagrangian points
  • total pressure loss
  • Mass Flow
  • guidance law
  • Buckling
  • aerodynamic efficiency
  • Spray
  • Axial turbine
  • OpenFOAM
  • optimal design
  • Flexible Satellite
  • angle of attack
  • optimal reliability modeling
  • sensor
  • Supersonic
  • turbojet engine
  • Fouling
  • experimental method
  • frequency response
  • Magnetohydrodynamic
  • neural control
  • Blowing ratio
  • near-Earth asteroids
  • Stress transfer
  • heat transfer rate
  • Comprehensive Preference-based Design (CPD)
  • Classic controller
  • third order shear deformation theory
  • power off
  • Aerodynamic forces
  • hardware-based satellite simulator
  • RANS
  • Cutout
  • MEMS inertial sensors
  • spiral atomizer
  • structural design
  • Navier-Stokes equation
  • Aircraft Design
  • Stall
  • design parameters
  • UAM
  • Modified Stir casting method
  • passenger aircraft
  • Triple Jets
  • navigation system
  • design structured matrix (DSM)
  • Bandwidth
  • Vibration Control
  • static coefficient
  • Inverse kinematic problem
  • \"Telescopic Booms\"
  • Flying Targets
  • nonlinear observer
  • improvement
  • Nonlinear dynamic
  • mini-turbojet engine
  • Aero gas turbine engine
  • functional guidance
  • impeller
  • space security
  • local damage model
  • diamond lattice
  • geometric secrecy
  • time delay
  • Output power
  • free transverse vibration
  • numerical flow simulation
  • linear regression
  • functionally graded viscoelastic materials
  • classical laminated plate theory
  • carbon nanotubes (CNT)
  • systematic design
  • Pressurized swirl injector
  • Multi-phase
  • social intelligence
  • thrust vector
  • Re-entry capsule
  • Decentralized Formation control \"
  • Probabilistic Neural Network
  • adhesively bonded joint
  • Electrical discharge machining
  • three dimensional elasticity
  • Volume Dynamics
  • pitch angle
  • flexural loading
  • extended state observer (ESO)
  • Uncertain Cost Function
  • Encrypted control
  • \"